SawStop T-Glide Fence System - Manual (Page 17)

Adjusting Your T-Glide Fence System
Once the left face plate has been removed, you can access the screws for the right face plate through the key-
hole slots for the left face plate (see Fig. 30). Loosen each screw in the right face plate just enough to allow the
face plate to slide against the fence, but tight enough so the face plate does not move freely. Install the fence
on the front tube and position the right face plate as desired, making sure to leave at least a small gap between
the bottom of the face plate and the table so the face
plate does not drag on the table.
Next, carefully lift the fence off the front tube and place
it on the table with the right face plate facing down.
Make sure not to move the face plate from the position
you set it. If necessary you can clamp the face plate to
the fence to keep the face plate from moving. Tighten
each screw to lock the right face plate in position.
Make sure not to over-tighten these screws as it
that may cause a slight concavity in the surface of
the face plate near the screw.
Replace the left face plate onto the fence and install
the fence on the front tube. Adjust the position of the
left face plate as desired. Lift the fence off the tube
and set it on the table with the left face plate down,
making sure the position of the face plate doesn’t
move. Tighten the screws to lock the left face plate
onto the fence.
Fig. 30
If necessary, you can adjust the position of the
indicator lenses on the front of the fence. To verify
the position of each indicator lens, clamp the
fence to the front tube and use a ruler to measure
the distance from the blade to the fence plate and
compare it to the measurement shown on the
proper indicator lens. If adjustment is necessary,
loosen the two Phillips screws shown in Fig. 31
and slide the indicator lens to right or left until the
cursor is directly over the correct measurement.
Tighten the screws to lock the position of the
indicator lens. Your fence is now fully adjusted
and ready to use.
Fig. 31
adjust the
indicator lens by
loosening the two
Phillips screws
SawStop T-Glide Fence System - Professional Series 15