SawStop T-Glide Fence System - Manual (Page 13)

Installing Your T-Glide Fence System
21. Once the fence is tightly clamped to the
front tube, move the left end of the tube back
toward the saw until there is only a small gap
(approximately 1/16”) between the front rail and
the rear of the fence (see Fig. 21). Tighten the
left-most M8 x 16 hex head screw that holds the
tube to the front rail using a 13 mm wrench.
22. Next, move the fence to the right end of the tube, repeat the above process to position the tube, and tighten
the right-most screw (see Fig. 22). Once both ends of the tube are adjusted correctly, tighten the remaining
M8 x 16 hex head screws to mount the front tube to the front rail. The fence should now slide smoothly along
the front tube without binding and without excessive play.
Fig. 21
Fig. 22
Congratulations, your fence system is now
installed and your saw is ready to use.
gap
gap
SawStop T-Glide Fence System - Professional Series 11