SawStop T-Glide Fence System - Manual (Page 16)

Adjusting Your T-Glide Fence System
If necessary, you can adjust both of the plastic leveling screws to ensure the position indicator lenses are close,
but do not touch the front tube or rulers.
The last step is to set the spacing between the bottom of each face plate and the table. The face plates are
held in place by a series of screws threaded into nuts embedded in the face plates. The heads of the screws
fit into key-hole slots in the sides of the fence (see Fig. 28).
It is usually possible to adjust the position of the face plates by lightly tapping the top or bottom edge of the face
plates with a plastic or wooden mallet. However, if the face plates do not move when tapped, you can loosen
the mounting screws as described below to adjust the face plates.
If the right face plate needs to be adjusted, you must first
remove the left face plate. Begin by laying the fence on
the table with the left face plate facing down. You can
access the screws for the left face plate through the slots
on the bottom of the fence. Insert a ball-end hex wrench
through the slot at the end of the fence and into the screw
head (see Fig. 29). Loosen the screw but do not unthread
it completely. Continue this process with each slot/screw
pair. It may be helpful to shine a flashlight down the end
of the tube to illuminate the screw heads. Once all the
screws are loosened, push the face plate downward to
align the screw heads with the large portion of the key-
hole slots, and then pull the face plate off the fence.
Fig. 28
Fig. 29
key-hole
slot
screw
head
14 SawStop T-Glide Fence System - Professional Series