SawStop T-Glide Fence System - Manual (Page 11)

Installing Your T-Glide Fence System
SawStop
6
17. Locate the front tube and the M8 x 16 hex head screws with attached washers from the T-Glide rails hardware
pack. Position the tube on the horizontal portion of the front rail with the rulers facing up and the 12 inch ruler
on the left side. The powder coated surfaces of the tube and rail can be slick, so be careful that the tube does
not fall off the rail. Align the holes in the rail with the holes in the bottom of the tube. Thread the M8 x 16 hex
head screws through the rail and into the threaded holes in the bottom of the tube (see Fig. 17). Hand tighten
the screws; do not fully tighten them.
Fig. 17
18. Locate the fence and the red fence handle. Thread
the handle into the cam lock on the front of the fence
(see Fig. 18).
Fig. 18
thread the handle into
the cam lock
T-Glide Rails Hardware Pack
1
Countersunk Socket Head Bolts,
M8 x 25 (8)
Lock Washers,
M8 (8) 3
Hex Nuts,
M8 (8) 4
Hex Head Screws with Attached
Washers, M8 x 16 (9) 6
Washers,
M8.5 x 23 (8) 2
Countersunk Socket
Head Screws, M8 x 16 (4) 5
SawStop T-Glide Fence System - Professional Series 9