Rivera Primo Powerdrive 6 Transmission Shifter Cam & Fork Assembly - Manual

INSTRUCTIONS
12450 Whittier Blvd. Whittier Ca. 90602
(562)907-2600 Fax: (562)907-2606
www.riveraprimoinc.com
Shifter Cam Assembly
Shifter Forks
Disassembly
Retaining Ring
1101-0061
Retaining Ring
1101-0062
Cam Bearing
1018-0016
Support Tower (LH)
1217-0641
Cam LSD
1217-0636
Coil Spring
1217-0645
Spring Hanger
1217-0640
Cam Follower Arm
1217-0639
Roller
1217-0646
Roller Shaft
1217-0644
Roll Pin
1217-0647
Support Tower (RH) LSD
1217-0642
Bearing
1018-0017
Shifter Cam Assembly
Exploded View
Fig.1
WARNING
To protect against accidental start-up of vehicle,
always disconnect the negative battery cable before
working on the motorcycle. Failure to disconnect the
battery cable could result in serious injury or death.
1. Remove battery negative cable (black) from battery
negative (-) terminal.
2. Remove exhaust system.
3. Remove the magnetic drain plug at the bottom right
side of the oil pan and drain the transmission fluid.
Remove the fill plug/dipstick.
4. Remove connector from neutral safety switch.
5. Remove the five socket head cap screws from the
transmission top cover. Remove the top cover from
the transmission case. Do not re-use the
top cover gasket .
6. Remove the four bolts and washers from the right
and left shifter cam support blocks. Raise the shifter
pawl and lift the shifter cam assembly from the
dowels on the transmission case.
7. If necessary, disassemble the shifter cam
assembly as follows:
a. Lift detent arm and slide right support block
off end of shifter cam. Remove pivot screw to release
detent arm,spring sleeve and spring. Remove
retaining ring (Do not re-use). If the needle bearing
is damaged, remove the bearing from the support
block by pressing it out and replace
with a new bearing.
b. Moving to opposite side, using a snap ring pliers
remove retaining ring from groove at left end of
shifter cam. Slide left support block off end of shifter
cam. DO NOT re-use retaining ring. If the needle
bearing is damaged, remove the bearing from the
support block by pressing it out and replace
with a new bearing.
WARNING
Always wear proper eye protection when removing
retaining rings. Failure to do so may result in eye injury.