Rivera Primo LED Lighting Kit for TransparaGuard - Manual

On/Off: Turn LED’s on & off
Modes: Cycles through various light modes.
(Take a moment and cycle through all the modes to familiarize yourself with the sequence).
Pause: Stop the LED’s on any color you like during the“Color Transition Modes”
LED Lighting Kit for TransparaGuard™
RPI Part # 2116-0001
Wireless RGB/multicolor controller with RF remote. Up to 30 yards range thru walls. Bat-
tery connections are simple 4” pigtail wires: the wire with the in-line fuse goes to your posi-
tive side while the other lead goes to the negative side. The connection for the LED array is
waterproof with a male and female mated coupler. There are 14 pre-programmed modes & 3
adjustable speeds on the color changing patterns.
• 13 functions RF remote control
• 9 light shows
• 3 steps of speed control
• On/Off button on remote control
• 12VDC 60W nominal output
• PVC housing
• In-line fuse holder on +12VDC input for added protection in automotive environments
Includes double sided adhesive strips for mounting.
Mount the controller box to the backside of the motorplate with one of the included double
sided ahesive strips. Mount the LED array to the front side of the motorplate with one of the
included double sided adhesive strips. Drill a 1/2” hole through the motorplate in an area
that will not intersect with any of the operation parts of the motorcycle of belt drive. Insert the
waterproof connector through the hole and attach it to the mating connector on the Controller
box. Attach the lead with the in-lne fuse to the positive terminal of the battery and the other
lead on the same side to the negative terminal on the battery. Be sure that the leads are posi-
tioned away from any moving or hot parts and then secure them in place.
Antenna
LED Array
Controller
RIVERA PRIMO INC.~12450 WHITTIER BLVD.~WHITTIER, CA 90601
562-907-2600~562-907-2606 FAX ~ WWW.RIVERAPRIMOINC.COM