Rugged Ridge Fender Flare Kit, 09-14 Ford F-150 - Manual (Page 6)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
All Terrain Flares 09+ Ford F150
12. Use supplied edge trim tool to seat edge trim
against vehicle with curved end; slide it under trim
along vehicle fender. Use flat end of tool to seat trim
againt flare; slide tool between trim and flare.
PAINTING:
1. Lightly sand flares with 320 grid sandpaper.
2. Remove all surface contaminants from flares using an
approved grease and wax remover.
3. Wipe flares with a tack rag to remove any dust or dirt.
4. Apply two even coats of adhesion promoter to flares.
Allow recommended flash time between coats. Let sec-
ond coat dry for 15 minutes before primer application.
5. Apply an even coat of primer to flare surface (a high
build primer is recommended).
6. Paint flares with an automotive grade paint (a flex ad-
ditive must be added to paint).
Page 5/5
81630.04
OMIX-ADA ® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com