Rugged Ridge Fender Flare Kit, 09-14 Ford F-150 - Manual

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
All Terrain Flares 09+ Ford F150
Page 1/5
Components:
1. Front Flares (2)
2. Front Flare Inner Pieces (2)
3. Rear Flares (2)
Tools required:
- Utility knife
- Electric Drill
- 1/4” Drill Bit
- #2 Phillips driver
- Socket wrench
- 7/32” Socket
- 3/8” Socket
- 10 mm Socket
- 13 mm Socket
-Grease Pencil
- 6 mm Allen Wrench
Hardware List:
1. M8 Socket Head Cap
Screw (34 pcs)
7. Roll of Edge Trim (30
ft.) 2. M8 Locking Hex Nut
(34 pcs)
8. Screw U-Clamp (2
pcs) 3. M8 Flat Washer (34
pcs)
9. Screw U-Clamp Long
(8 pcs)
4. Retainer Rivet Screw
(8 pcs)
5. Edge Trim Tool 10. Plastic Square Tab (8
pcs)
6. #10 Philips Screw (10
pcs)
81630.04
Rev - 09/2013
Read all instructions thoroughly before installation.
OMIX-ADA ® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com