Team Associated TC6.2 - Manual (Page 19)

19
:: Steering / Caster Blocks Build - Bag F - Step 8
:: Steering / Caster Blocks Build - Bag F - Step 9
:: Steering / Caster Blocks Build - Bag F - Step 10
31162
Axle shim
31359
TC6.1
rear hub
carrier
31359
TC6.1
rear hub
carrier
inserts
(0 deg)
x2
25237
5x10mm
bearing
31286
Aluminum
ballstud
washer
(2mm)
x2
31370
TC6.1
axle crush
tube
31284
8mm
ballstud
(long)
It is important that the turnbuckle eyelets move freely
once snapped on to the ballstud. If the fit is too tight,
the car handling will be inconsistent. To check, grab
turnbuckle eyelet with fingers and rotate the cup. If
there is resistance, lightly squeeze ball cup with needle
nose pliers as shown and test again. It is important
that the ball cup be snapped onto the ballstud before
squeezing with needle nose pliers. Be sure to check
and adjust the fit for each ball cup that is installed.
!
RACERS TIP:
Use small amount of ca
glue to permanently secure
the rear hub inserts in the
hubs.
Use the supplied
symmetric inserts to select
rear hub toe angle.
When viewed from the
back, the number should
be located on the outside
of the hinge pin, as shown
in the view to the right.
When viewed from the
front, the number should
be located on the inside
of the hinge pin.
!
0 0
Right Left
!
!