NaceCare Solutions ST732 - Manual (Page 19)

18
DAILY MAINTENANCE
CLEANING SUCTION FILTER
1. Lift the cover
2. Take off the suction plug by rotating it counter-clockwise
3. Remove the filter
4. Clean the filter with clean warm water
5. Wash all of the components thoroughly
CLEANING SOLUTION FILTER
1. Close the water valve
2. Unscrew the filter located under the rear left side of the machine
3. Extract the cartridge from the filter and clean it with warm water
4. Reassemble the water filter
CLEANING THE SQUEEGEE
In order to have the best drying results, check that the squeegee is always
clean.
To clean the squeegee, you must:
1. Take off the hose (1) from the squeegee
2. Release the squeegee
3. Clean the inside of the squeegee thoroughly
4. Clean the squeegee blades thoroughly
5. Reassemble the squeegee to the machine
REPLACING THE REAR SQUEEGEE BLADE
If the rear squeegee blade is worn and does not dry well, you must change
the drying edge proceeding as follows:
1. Push and turn the support plates (1) as shown in the figure.
2. Slip off the rubber blade and the rubber itself
3. Turn the rubber (2) upside-down and if necessary, replace it
4. Reassemble the squeegee
5. Adjust the squeegee height depending on the wear of the blade (see
“ADJUSTING THE SQUEEGEE”)
1
2
3