NaceCare Solutions ST732 - Manual (Page 10)

9
MACHINE PREPARATION
8. SQUEEGEE ASSEMBLY
The squeegee, which is packed separately from the machine, should be
assembled as shown in the figure. Insert the left squeegee pin (1) in the left
arm slot, then the right pin (2) into the right slot, paying attention to keep the
spring and the washer over the blade of the arm itself. To simplify this
operation the hand-wheel placed on top of the pin should be loosened when
installing the squeegee. Tighten the hand-wheel to lock the squeegee in
position.
Fit the squeegee hose into its coupling (3)
2
3
1
9. ADJUSTMENT SQUEEGEE HEIGHT
The squeegee has to be adjusted depending on the wear of the squeegee
blades. To adjust this, rotate the knob (1) of each wheel clockwise to lift the
squeegee and counter-clockwise to lower it.
Note: The right and left wheels must be adjusted at the same amount so that
the squeegee sits parallel to the floor.
10. ADJUSTMENT SQUEEGEE PITCH
During working operation, the rear blade has to be tilted backwards approx.
5mm across the whole length of the squeegee. The squeegee pitch
adjustment (1) should only be adjusted if the center of the squeegee is not
touching the floor properly. To tilt the squeegee down, turn the adjustment bolt
(1) counter-clockwise until the proper adjustment is reached. To tilt the
squeegee up, turn the adjustment bolt (1) clockwise until the proper
adjustment is reached. After the adjustment is made, remember to lock the
lock nut back in place on the adjustment bolt.