NaceCare Solutions ST732 - Manual (Page 11)

10
MACHINE PREPARATION
11. BRUSH ASSEMBLY
1. Lift the brushes base using the pedal (1)
2. lock the lever in position (2)
3. Turn the key into position “0”.
ATTENTION! Always ensure that the power is off and the battery
connector is disconnected before mounting or dismounting the
brushes. Failing to do so can result in bodily injury.
4. With the brush base in the up position, insert the brushes into the seat of
the plate under the base until the three lugs fit into the holes of the plate.
Turn the brush so that the lugs are pushed towards their retaining springs
and locked in to place. The figure shows the direction to lock on the right
brush. When locking on the left brush, you will need to spin it the opposite
way.
5. You should swap the position of the brushes daily. If the brush bristles
have started to deform, they should be installed on the same side all of the
time to avoid excess load on the brush motor.
1
2