NaceCare Solutions ST732 - Manual (Page 14)

13
USING THE MACHINE
SET UP
1. Connect the machine connector to the battery connector(1)
2. Turn the key switch (2) into position I (clockwise). Immediately, the battery
indicator comes on (3)
3
2 1
0 I
3. Press the traction motor switch forward (1)
4. Press the brushes motor switch forward(2)
5. Press the suction motor switch forward(3)
6. Press the solenoid valve switch forward(4)
3
2 1
4
7. Adjust the quantity of the detergent by lever (1). Please keep in mind that,
the correct solution quantity depends always on the type of floor, the dirt
and the speed.
8. Lower the brush base using the pedal (2) and releasing the lever (3)
9. Lower the squeegee using the pedal (4) and unhook the lever (5)
10. Check that the parking brake (5) is released
10. Push the traction control lever (1) forward, so that the machine starts to
move forward and the brushes start to turn. Check that the quantity of
solution is sufficient and the squeegee dries the floor.
The machine is working now until the cleaning solution is used up.
1
1
2
3
4
5
6