Beijer Electronics MTe Nautic EN - Manual (Page 38)

Operation
38 Beijer Electronics, MAEN983B
Setting the Display in Extended Mode
In extended mode, the d.client USB forms part of the extended Windows desk-
top.
1. To set the display in this mode, check the Extend my Windows desktop
onto this monitor box (marked 1 in previous figure).
2. Configure screen resolution and color quality using the appropriate controls
(2 and 3), and arrange its position with respect to the other monitors on the
extended desktop in using the drag area (4).
3. For more detailed mode settings, including the refresh rate, click on the
Advanced button, then the Adapter tab and finally the List all modes…
button. All valid combinations of resolution, color quality and refresh rate
are listed.
Setting the Display in Mirror Mode
In mirror mode, the d.client USB simply copies what is on the main (primary)
display.
1. To set the display in this mode, uncheck the Extend my Windows desktop
onto this monitor box (marked 1 in previous figure).
The resolution, color depth and refresh rate of the primary screen are replicated
on the d.client USB.
If the d.client USB display unit supports a lower resolution than the primary dis-
play, the on board scaling engine will downscale the image to the native panel
resolution.
Setting the Display as the Primary Display
To make the d.client USB unit the primary display, check the Use this device as
the primary monitor (marked 1 in previous figure). On some PCs it is necessary
to disable the main display (i.e. unchecking the box marked Extend my Win-
dows desktop onto this monitor for the main display) as part of the same set-
tings change. The d.client USB display stays primary if the PC enters hibernate
or suspend mode or is rebooted. If the d.client is detached, the main display be-
comes primary again.