Vaddio WallVIEW PRO 300 - Manual (Page 2)

WallVIEW PRO 300
WallVIEW PRO 300 Installation and User Guide 341-668 Rev. B Page 2 of 10
UNPACKING
Carefully remove all of the parts from the packaging and identify the following parts for the WallVIEW PRO
300 system:
• One (1) - Sony BRC-300 Standard Definition PTZ Camera
• One (1) - Vaddio EZ Interface Module (EZIM)
• One (1) - Vaddio EZIM to SD Break Out Cable
• One (1) - Vaddio Quick-Connect PRO (1-RU Rack Mountable)
• One (1) - Vaddio Thin Profile PRO Wall Mount
• One (1) - Sony IR Remote Control
• One (1) - EZCamera Control Adapter (RJ-45 to DB-9)
• One (1) - 36V PowerRite Power Supply with AC Cord Set
• One (1) - 2-position Phoenix Connector for IR
• Mounting Hardware
• Documentation
ƒ Vaddio Manual
ƒ Sony BRC-300 Manual
INSTALLATION
All WallVIEW products are specifically designed for installation on a vertical wall surface with Cat. 5 cable
connectivity for Power, Video and Control signaling. Installation is simplified in that no custom 8-Pin mini-din
cables or expensive S-Video plenum cables are needed and no power outlets are required near the camera
bracket. All cabling is routed to the head-end using Cat. 5 cables.
Before Installing
• Locate the camera mounting location paying close attention to camera viewing angles, lighting conditions,
possible line of site obstructions, and checking for in-wall obstructions where the camera is to be
mounted. Pick a mounting location to optimize the performance of the camera.
• Pre-wire all cabling as required (see wiring diagram examples).
• The Thin Profile Wall Mount for the WallVIEW 300 can be mounted directly to a 3-gang wall box or can
be mounted to the drywall using four dry wall anchors.
Wiring Diagram Example
Daisy Chain Control Configuration:
Video (Y-C and Composite)
to VC codec or other device
36 VDC PowerRite
Power Supply
IR Output
WallVIEW 300 with Camera,
Wall Mount and EZIM
(behind camera)
Quick-Connect Pro Rack
Mount Interface
Up to 500’ (152.4m) of Cat. 5
for Power, Video and Control
Power Cat. 5
Video Cat. 5
Figure 2: Basic connectivity of the WallVIEW 300 System.
The WallVIEW PRO uses a Cat. 5 (all 4-pairs) for power to ensure the motors receive the required current to
operate properly. The Video Cat. 5 uses 3-pairs of the Cat. 5 for Video and 1-pair for IR forwarding. The RS-
232 Cat. 5 uses 5 conductors for RS-232 with provision for daisy chain controllers. These Cat. 5 cables can
be run up to 500’ (152.4m). See Appendix 1 for wiring and pin-out information.
RS-232 Cat. 5