Vaddio WallVIEW PRO 300 - Manual

Installation and User Guide
Camera and Electronic Products for Integrators
©2008 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and pricing subject to change. Vaddio,
WallVIEW, HSDS, Quick-Connect, EZIM and PowerRite are registered trademarks of Vaddio, Inc. All other trademarks are property of their respective owners.
Document Number 341-668 Rev. B.
W
ALL
VIEW™ PRO 300
WITH
HSDS™
Vaddio™ Pro Series Cable System with
High Speed Differential Signaling for the
Sony® BRC-300 PTZ Camera
OVERVIEW
The Vaddio WallVIEW PRO 300 (Figure 1) is built
around the Sony BRC-300 standard definition PTZ
Camera. The WallVIEW PRO 300 uses high speed
differential signaling (HSDS), an active transmission
system that delivers low-loss, high-quality video over Cat.
5 cabling distances up to 500 feet. The WallVIEW PRO
300 system is capable of standard definition (SD)
resolutions in a variety of screen configurations to fit
most monitors. The BRC-300 is offered in either NTSC
or PAL formats.
The WallVIEW PRO system also has many new features, including a unique IR forwarding system which
allows the user to forward IR commands from Sony® or Polycom® IR remote controls, through the WallVIEW
system to a third party device, such as a videoconference codec (see Figure 2). Other new features include
analog Y-C (S-Video) and composite outputs on BNC connectors, four position distance adjustment for Cat.
5 cabling, Y-Gain adjustment, and the EZ Interface Module (EZIM). Like all Vaddio WallVIEW systems, the
Thin Profile Wall Mount and mounting hardware is included.
INTENDED USE
Before installing the Vaddio WallVIEW PRO Camera System, please read the entire manual thoroughly. All
Vaddio camera systems are designed for use indoors. Outdoor operation is not recommended, has not been
tested, and could damage the camera and/or create a potentially unsafe operating condition. Use only the
Vaddio PowerRite power supply provided.
SAVE THESE INSTRUCTIONS
The information contained in this manual will help you install the Vaddio WallVIEW PRO system. For
reference, Vaddio keeps copies of Specifications, Installation and User Guides and most pertinent product
drawings for the Vaddio product line on the website. These documents can be downloaded from
www.vaddio.com free of charge.
IMPORTANT SAFEGUARDS
Read and understand all instructions before using. Do not operate the any electrical device if it has been
dropped or damaged. In this case, a Vaddio technician must examine the product before operating. To
reduce the risk of electric shock, do not immerse in water or other liquids and avoid extremely humid
conditions.
INFORMATION
For RS-232 control information, please see the full-length Technical Manual for the Sony BRC-300. This
manual can be found either on the Vaddio or Sony website. Vaddio has also prepared a number of
TechNotes, specifications and drawings designed to inform and educate integrators on the value and the
specific uses of Vaddio products.
Figure 1:
WallVIEW PRO 300 System with Camera,
Wall Mount and EZIM (behind camera)
Use only the power supply provided with the Vaddio WallVIEW products.
Use of any unauthorized power supply will void any and all warranties.