Vaddio Quick-Connect PRO and WallVIEW PRO for AW HE120 User Manual

Page 9

Quick-Connect PRO and WallVIEW PRO for the AW-HE120 Camera

Page 9 of 16

Step 3: Take the Wall Mount, with the EZIM and break out cable installed, and place it against the drywall
anchors or 3-gang wall box, making sure to pull the three Cat-5 cables through the oval pass-through hole.
Finger-tighten the screws to the mount and confirm that the base is level. Tighten the screws firmly. If the
bracket is to be mounted on a 3-gang wall box, use the screws supplied with the electrical box.

Step 4: Three (3) Cat-5 cables are required to connect the Panasonic AW-HE120 camera. Confirm that the
Cat. 5 cables are terminated correctly, by testing them with a continuity tester. Connect the break out cables to
the appropriate ports on the AW-HE120 (YPbPr and Power). Push the camera into place and dress the cables.
Secure the camera to the mount and using the supplied ¼”-20 screws.

Step 5: The Quick-Connect Pro Series Interface is a 1-RU rack mount interface that breaks out the signals from
the Cat. 5 cables back to the standard connectors.

Step 6: Assemble the RS-232 to RS-422 converter. There are two (2) RJ-45 to DE-9 adapters; one has a
female 9-pin and the other has a male 9-pin. Connect the DE-9 ends to the RS-232 to RS-422 adapter, and
screw the parts together, using the supplied hardware. The basic system connectivity is illustrated below.

Drawing: Wiring Diagram of Basic Connectivity (the basic idea)

The Quick-Connect PRO Interface uses a Cat-5 (all 4-pairs) for power to ensure the motors receive the required current to operate
properly. The Video Cat-5 cable uses three pairs for video YPbPr. The RS-232 is converted to RS-422 and that Cat-5 is routed
directly to the camera providing communication to the camera. These Cat. 5 cables can be run up to 500’ (152.4m). See
Appendix 1 for wiring and pin-out information. NOTE: Daisy-Chain configurations are not supported

HD-YPbPr

POWER

Not Used

Panasonic AW-HE120
On Heavy Duty Mount

Multi-Viewer Preview Monitor

Program Monitor

Simulated Video Feed

36VDC Power
Supply

Quick-Connect Pro
Series Interface
Rear Panel

Cat-5 Cables

up to 500’

(152.4m)

3’ (.91m) Cat-5e

Patch Cable (provided)

RS-232

RS-422

Converter

RS-422

HD Break-out

Cable

EZIM Top Panel

EZIM, break-out cables are
dressed and put behind camera

Power on
4-pair

HSDS
Video
Returned

HD-YPbPr
Video

ProductionVIEW HD MV with Built-in Multi-viewer