Vaddio EasyTalk Solutions Manual - Manual (Page 19)

EasyTalk USB Tools
Vaddio EasyTalk USB Solution - Document Number 342-0449 Rev B Page 19 of 48
System Connection Diagrams
The EasyTalk USB Solution can be used in a wide range of conferencing applications with the flexibility to work in
both new and existing installations. The product supports plug-and-play installation with user selectable dip
switches associated with audio mixing modes and advanced signal processing.
The EasyUSB Mixer/Amp is designed to support both the EasyMic MicPOD (tabletop version) and EasyMic
Ceiling MicPOD (ceiling version) in any combination. The applications below depict common conferencing
applications and configurations that can be supported with the EasyTalk USB solutions.
PC-based USB Conferencing Application:
The diagram below depicts a typical EasyUSB connection diagram when used with PC soft-clients (Jabber,
Skype, Lync) for the group audio system. The EasyMics are connected to the EasyUSB Mixer/Amp with CAT-5
cable and speaker outputs are connected to the EasyTalk Sound Bar. The USB connection to the PC is a UAC
device allowing selection of EasyUSB Mixer/Amp as the playback and recording device within the operating
system.
Diagram: PC with USB 2.0 Basic Conferencing Connection Diagram
Mixer/Amp
PC with UC Client Software
+
+
_
_
+
_
+
_
EasyTalk Sound Bar - Rear View
Left and Right Channels Used
Supplied
Speaker Wire
Two 6’ (1.8m)
Cables
Included
Supplied
CAT-5e
Cables
Two (2) 25’
(7.62m)
Cables
EasyUSB
Mixer/Amp
Front Panel
EasyUSB
Mixer/Amp
Rear Panel
Two (2) EasyMic
MicPOD Table Mics
Uses UAC
(Universal
Audio
Class)
Drivers USB 2.0
Cable
8 ohm 8 ohm