Vaddio EasyTalk Solutions Manual - Manual (Page 11)

EasyTalk USB Tools
Vaddio EasyTalk USB Solution - Document Number 342-0449 Rev B Page 11 of 48
Diagram: EasyMic Ceiling MicPOD Array Head
1) Trim
Cover: The trim cover screws onto the 5/8” Feed-Through Coupler on the Ceiling Interface Module
providing a dressed appearance for ceiling installations.
Remember to keep the pilot hole in the tile or drywall as close to 5/8” as possible
2) Array Head Drop Cable: A 36” cable terminated with a RJ-45 jack and provides the connection of the Array
Head with the processing board housed in the Ceiling Interface Module.
3) Array Head: The array head is 2.5” diameter microphone that provides 360 degree sound pick‐up coverage.
EasyTalk Sound Bar: The EasyTalk Sound Bar is a passive LCR sound bar that
uses long-excursion 3.75” paper cone woofers for superb bass extension and
dynamic impact, especially for voice. It uses 5/8” Aluminum tweeters for realistic
highs. The fit and finish of the EasyTalk Sound Bar adds style to any décor. It is
packaged with a pair of rubber feet for table mounting and has keyhole slots and M5
threaded inserts on the back for additional mounting options.
The EasyTalk Sound Bar can be positioned above or below a wall mounted LCD Display or sit free standing.
While it has three channels, LCR (left, center, right), but only two channels, L&R, are needed for use with the
EasyUSB Mixer/Amp.
EasyTalk Ceiling Speakers: The EasyTalk Ceiling Speakers include two (2) Bose
DS16F loudspeakers, two (2) tile support braces and two (2) plenum back boxes.
The loudspeakers are intended for flush mount ceiling applications. The speakers are
capable of supporting 8ohm or 70/100V amplifier systems. Connection with the
EasyUSB Mixer/Amp should use the 8 ohm termination. Termination selector is
located under the loudspeaker grille on a rotary switch; set to 8 ohms. See the
provided Bose manual.
➌
➊
➋