Vaddio EasyTALK Wireless USB Mic System - Manual (Page 7)

EasyTalk Wireless Mic
EasyTalk Wireless USB Mic System - Document Number 342-0442 Rev A Page 7 of 16
Diagram: Belt Pack Control Panel
1) Lav Mic Cable Connector (5-pin mini XLR - M):
Plug the cable attached to the Lanyard into the 5-pin mini
XLR connector.
2) Radio: This LED indicates an active radio link with the EasyTalk Wireless Receiver. Solid blue LED indicates
connection with the EasyTALK Wireless Receiver. Flashing blue LED indicates radio link has been lost.
 Note: Radio link operates up to 100 feet line of sight from the Belt Pack Transmitter to the EasyTalk
Wireless Receiver.
3) System Power: To use the Belt Pack or IR Lanyard, turn the SYSTEM POWER switch to the on position and
the LED will illuminate. Be sure to turn off the SYSTEM POWER switch when the system is not in use to
save the battery life. The rechargeable lithium-ion battery pack provides up to ten (10) hours with full charge.
It is highly recommended that the Rechargeable Lithium Ion Battery Pack be fully charged prior to
using the Belt Pack for the first time!
4) Microphone ON/OFF: This switch turns the wireless microphone on or off at the Belt Pack allowing the
presenter to use an existing room system microphone instead, or for momentary microphone muting.
 Note: The System Status light on the EasyTalk Wireless Receiver will light if the microphone signal
is detected. If the Microphone is turned off at the Belt Pack, the System Status light will not light.
5) 1” ¼-Wave Antenna: Used to transmit the wireless microphone audio back to the EasyTalk Wireless
Receiver.
①
②
③ ④
⑤