Vaddio ControlVIEW XHD - Manual (Page 7)

ControlVIEW XHD
ControlVIEW XHD Manual 341-917 Rev. C Page 7 of 24
Figure 4: ControlVIEW XHD IR Remote Control
Vaddio Accessories for ControlVIEW XHD
Vaddio Accessory Cable Part Numbers
440-5600-000 – 15-pin to SD (CVBS & Y-C) breakout cable (female BNCs – 1 foot)
440-5600-001 – 15-pin to HD/SD Component (YPbPr/RGBHV) cable (male BNCs – 3 foot)
440-5600-002 – 15-pin to HD/SD Component (YPbPr/RGBHV) cable (male BNCs – 6 foot)
440-5600-003 – 15-pin to HD/SD Component (YPbPr/RGBHV) cable (female BNCs – 7 inch)
Vaddio Presence Sensing Trigger Devices
999-1511-000 – StepVIEW Mat 44” x 27.5” with 75’ attached cable
999-1512-000 – StepVIEW Mat 57” x 27.5” with 75’ attached cable
999-1701-100 – AutoVIEW IR Sensor, interface controller, cable and power supply
Vaddio MicVIEW Trigger Devices
999-0001-000 – MicVIEW 12 input Mic Switcher/Mixer
701-0001-891 – Unidirectional Boundary Microphone
Vaddio TouchVIEW Trigger Device
999-1201-000 – TouchVIEW System with 4 RF buttons & 1 Receiver
1
2
3
4
5
6
7
8
9
1. Power: Pressing the Power button will turn the
system on. Press and hold the Power button for
3 seconds to turn on or off the system.
2. Transition Select: Pressing the up or down
button will switch the type of transition from wipe,
fade or cut. The wipe that is currently selected
via the internal menu will be the wipe transition
that occurs.
3. Preset Control: Use the 0-9 buttons to program
and recall preset camera positions. Preset
Disable turns off all presets camera positions that
are programmed into the system.
4. Zoom: Press the in and out buttons for zoom
control of the selected PTZ camera.
5. Input Select: Pressing the 1-6 buttons selects
which input will be sent to the outputs.
6. Priority: Pressing First, Last or Multi buttons will
choose the Step function for the input triggers on
the system. Inputs 1-12 are multi-step triggers. All
other triggers in Multi-Sep mode will act as Last
Step.
7. Program: Pressing the Program button initiates
the program feature of the system, allowing the
PTZ camera positions and inputs to be selected.
8. Transition Time: Pressing the up and down will
increase or decrease the transition time from 0.1
to 4 seconds for wipe or fade transitions.
9. PTZ Camera: Th ese buttons move the pan and
tilt of the selected camera. Pressing the Home
button moves the PTZ camera to the home
position.