Pulsafeeder Pre-Engineered Skid Systems - Manual (Page 23)

Pre-Engineered Skid Systems
Installation, Operation and Maintenance Manual
PES00039, Rev. B Appendix – Table 1 Page 23
Table 1 – Factory Pre-sets for Components
Pump, if furnished with Skid, and System Description Component Settings at Factory
Pump Data
System
Configuration
Calibration
Column Size
Back Pressure
Valve
Pressure Relief
Valve*
Pulsation
Dampener
Air Pressure** Size GPD PSI
K2 3 300
Standard 200 mL
50 PSI
150 PSI 120 PSI
12 5
250
B2 5
2 6
C2 6
C3 10
33 12
D3 12
F4 20
H4 41
A2 6
150
13 12
B3 12
34 22
D4 22
G4 42
K5 60
H5 76
3 12
100 100 PSI
80 PSI
A3 12
K3 14
4 24
14 24
B4 24
64 30
44 44
E4 44
G5 96 110 110 PSI
H6 120 100 100 PSI
54 30 80 80 PSI 60 PSI
C4 48 50 25 PSI 50 PSI 40 PSI
J7 240 80
HF
(High Flow)
1000 mL
50 PSI 80 PSI 60 PSI
K7 192 50 25 PSI 50 PSI 40 PSI
H7 240 35
20 PSI
35 PSI
25 PSI
H8 600 30 30 PSI
Note:
*Pressure Relief Valve setting at factory is based upon pump and skid components furnished.
You must determine your system pressure limit. If less than the factory pre-set, you must re-set
the Pressure Relief Valve accordingly.
**Pulsation Dampener air pressure values shown are factory pre-sets.
You must re-set the Pulsation Dampener air pressure to 80% of your system pressure or 80% of
the Back Pressure Valve setting, whichever is greater. Never set higher than 120 PSI.