Pulsafeeder Eclipse Model 75 - Manual (Page 30)

24
4. Install o-rings (items 6, 15) into each side of the center housing (item 14) as shown. Some o-ring lubricant
may help keep the o-rings in place during assembly. Be sure both o-rings are fully seated into housing
grooves.
5. Place the center housing, with o-rings, onto the motor spool, aligning the port connections between any set of
motor spool bolt holes as shown. Add the retaining plates (item 32). Secure with eight bolts and washers
(items 16, 17). Tighten these bolts to the torque specified in Section 12. Always tighten fasteners in a
progressive “crisscross” pattern.
Figure 27
6. Insert a bearing (item 10) into center housing and slide to bottom of bore. Bearings are symmetrical and
orientation does not matter. Install the housing liner (item 11) and slide until it seats against the first bearing.
Install idler gear (item 12) into the top hole in bearing until the gear seats against the first bearing.
7. Install the drive gear (item 13), splined-end first, into the assembly until it bottoms out against the bearing.
The shaft may have to be rotated slightly to properly fit the splined-end into the drive magnet and mesh gear
teeth with the idler gear.