Power Soak MX-220-H Owner's Manual - Manual (Page 21)

20
Facility Owner/Manager Section
The only troubleshooting procedure that the facility owner or
manager can perform is listed immediately below. All other
procedures must be performed by an authorized service agency. To
obtain the name of a recommended service agent in your area,
please call the Metcraft, Inc. Power Soak Service Department at
800-444-9624.
Pump and Heater do not work
Please perform the following in order:
• Drain the sink.
• Turn off the circuit breaker for your sink.
• Clean the liquid level sensor (LLS). This is located on the right or left inside wall
(same side as control panel) of the wash sink, behind the removable baffle. The
LLS is a white plastic disk with a silver metal center. Use warm soapy water.
• Fill the sink.
• Turn on the circuit breaker for your sink.
• Start the sink.