Power Soak MX-220-H Owner's Manual - Manual (Page 10)

9
Adding Detergents & Sanitizers
Manual Chemical Dispensing
After the sinks have been filled with water, add the proper amount of detergent and
sanitizer. The detergent goes into the wash sink (the sink with the water jets) and the
sanitizer goes into the sanitizer sink (the last sink).
Be sure to add the proper amount of chemicals to each sink. The amount to be used should
be provided by your chemical supplier. Do not add the detergent or sanitizer to the sink
prior to or during filling.
Automatic Chemical Dispensing
Your Power Soak may be equipped with an automatic chemical dispensing system. Be
sure to follow the chemical company’s instructions regarding the use and care of the
dispenser.
Wash Cycle
Most detergents and sanitizers lose effectiveness as time goes on. Some local health
departments have requirements limiting the amount of time water can be used for cleaning
before the water should be changed. Most chemical companies recommend changing wash
water after a certain time frame. Those times vary, but are generally around four hours.
Check with your chemical provider.
Your Power Soak sink is equipped with a timer preset at four hours. This means that your
Power Soak will turn off four hours after pressing the start button.
The following steps should be taken after the sink times out:
• Empty the wash sink
• Refill with fresh water
• Add your detergent
• Press the Start button
Check with your chemical provider on how often to replace your sanitizer.