Pitco Frialator REDUCED OIL VOLUME FRYING SYSTEM for SELV14 - Manual (Page 34)

SELV INSTALLATION & OPERATIONAL MANAUAL
34 L20-406 Rev 5 (3/14)
14.3 COMPUTER & DIGITAL CONTROLLER DISPLAYS
If your appliance is equipped with a computer or digital controller it may display the following messages
on its display.
Display Problems Action
Controller is OFF Press [I/O] key to turn controller ON
Oil/shortening temperature is low.
Fryer is slowly heating. Wait for appliance to heat up.
Oil/shortening temperature is low.
Fryer is slowly heating. Wait for appliance to heat up.
Oil/shortening temperature is low.
Fryer is heating. Wait for appliance to heat up.
Oil/shortening is at temperature
and ready to cook. Perform cooking activites as needed.
Drain valve is open while controller
is on. Turn off appliance. Close drain valve
before turning appliance back on.
Ignition system has locked out. Refer to Fryer Troubleshooting section
Oil/shortening has reached an
unsafe temperature. Turn off appliance. Allow time for
applicance to cool before turning on.
Incorrect probe reading. Contact a qualified service technican.
Temperature probe is shorted. Contact a qualified service technican.
This message indicates that oil in
the vat is in need of polishing. Operators may (depending on settings)
polish now, or defer the polish filter
operation for a later time.
Incorrect probe reading. Contact a qualified service technican.