13 troubleshooting, 1 power failure, 2 high temperature limit – Pitco Frialator REDUCED OIL VOLUME FRYING SYSTEM for SELV14 User Manual
Page 31: 3 drain valve interlock
SELV INSTALLATION & OPERATIONAL MANAUAL
31 L20-406 Rev 5 (3/14)
CAUTION
DO NOT attempt to operate this appliance during a power outage.
Picture 1
Use a flat screw driver to
remove the screw marked
“Reset Button”(Full pot
shown). SELV14T reset
buttons are under the outer
Screws.
13 TROUBLESHOOTING
13.1 POWER FAILURE
If electric power is removed for any reason, the appliance will shut down.
To restart the appliance, follow the appliance start up procedure in (See section 3.3.)
13.2 HIGH TEMPERATURE LIMIT
This appliance is equipped with a high temperature limit switch. The high temperature limit switch will
stop the appliance from heating if the internal cook tank reaches an unsafe temperature. In the event
that the high temperature limit has tripped, Please refer to the following procedure to reset the switch.
a. Turn the appliance off.
b. Allow the appliance time to cool to room
temperature.
c. Add oil to the cook tank as needed.
d. Remove the access screw located under
the basket support. Picture 1.
e. Use a small diameter tool ( 1/8”
maximum) such as a small Philips
screwdriver to press the reset button.
Picture 2.
f. Install the Access cover screw.
g. The high limit switch is now reset and the
appliance is ready for start up.
h. If the reset becomes tripped again,
discontinue using the fryer, and call for
service.
13.3 DRAIN VALVE INTERLOCK
Your appliance is equipped with a drain valve interlock circuit to prevent the appliance from heating if
the frypot drain valve is opened. Refer to the following procedure to resume operation after the drain
valve interlock is tripped.
1. Turn the appliance OFF.
2. Close the tank drain valve and fill the tank with oil/shortening.
3. Turn the appliance ON.
WARNING
DO NOT add oil to the frryer until it has been given ample time to cool down. Failure to do so
may result in damage to the appliance and/or injury to the operator.
Picture 2
Use a small diameter rod
(1/8” max.), or a Philips
screwdriver to reach through
the access hole and press
the reset button.