Nor-Lake Ice Cream Hardening & Holding Cabinets Models NX362WWW/4 User Manual
Page 3

3
151555 Rev. A 07/12
INTRODUCTION
This manual contains important instructions for installing, using, and servicing your Hardening and
Holding Cabinet case. A parts list is included with this manual. Read all these documents carefully
before installing or servicing your equipment.
STORE CONDITIONS
The Hardening and Holding Cabinet cases are designed to operate in the controlled environment of
an air-conditioned store. The store temperature should be at or below 75°F and a relative humidity of
55% or less. At higher temperature or humidity conditions, the performance of these cases may be
affected and the capacity diminished.
The Hardening and Holding Cabinet should not be positioned where it is directly exposed to rays of
sun or near a direct source of radiant heat or airflow. This will adversely affect the case and will result
in poor performance.
If this case is to be located against a wall, there should be at least 4” space between the wall and the
back of the case. This space will allow for the circulation of air behind the case, which will prevent
condensation on the exterior surfaces.
NOTICE
Read this manual before installing your cabinet. Keep the manual and refer to it before doing any
service on the equipment. Failure to do so could result in personal injury or damage to the cabinet.
DANGER
Improper or faulty hook-up of electrical components on the refrigeration units can result in severe
injury or death.
All electrical wiring hook-ups must be done in accordance with all applicable local, regional or
national standards.
NOTICE
Installation and service of the refrigeration and electrical components of the cabinet must be
performed by a refrigeration mechanic and/or a licensed electrician.
The portions of this manual covering refrigeration and electrical components contain technical
instructions intended only for persons qualified to perform refrigeration and electrical work.
This manual cannot cover every installation, use or service situation. If you need additional
information have the serial number at hand and call the Customer Service Department.