Merrychef 402s - Manual (Page 45)

402s Ovens Pt. No. 32Z3522 Issue 6
45
1. Switch the oven OFF
2. Switch ON and
immediately press
Edit Preheat to show
the ENTER
PREHEAT TEMP
screen.
3. Make a note of the Preheat temperature in
the display.
402s Version 3.0 models
1. Switch the oven OFF
2. Switch ON and
immediately press
Profile to edit the oven
operating profile
3. Press Change to set
OVEN MODE to
PROGRAM/MANUAL
To set the PREHEAT temperature to 0ºF/OFF
1. Switch the oven OFF then
2. Switch ON and immediately press the lower right
pad to display the OVEN PROFILE screen.
merrychef
Profile Change
OVEN MODE
PROGRAM/MANUAL
Next Change
merrychef
Profile Edit Preheat
ENTER PREHEAT TEMP
Save
000ºF
Engineering Test Settings - Changing the Oven Profile
In order to carry out an oven test procedure the oven PREHEAT must be set to 0ºF/OFF to
switch off the convection heaters and the Manual controls must be enabled.
When the test is completed the oven must be returned to its original settings or the
appropriate MenuKey can be used to reset the oven automatically.
To set the Oven controls to allow Manual operation
3. Make a note of the Preheat temperature in the
display.
Press +>> for OFF
( note pressing either +>> or << - will cycle
through all the available temperatures)
Then Press Save to store this setting
1. Switch the oven OFF
2. Switch ON and immediately press Edit Preheat
Temp.
402s Version 2.0/ 2.5
To use Manual Mode: from the CATEGORIES
standby screen press the lower centre right pad
To display the Manual mode screen.
3. Press to set Manual Mode to ON Then Press Save
Then press Next five times to return
to the OVEN COLD standby screen.
To use MANUAL MODE:
from the OVEN COLD/PRESS PREHEAT
standby screen press the PREHEAT/
COOL DOWN pad on the control panel
and then press Manual.
READY
TO COOK AT 000ºF
Run Prog Manual
4. Press 0, 0, 0 to overwrite the current
temperature setting.
Then press Save to
store this setting
APPENDIX 6: Engineering Test Settings