HOUNO KPE & CPE - Manual (Page 41)

CPE & KPE – ver. 3.x – August 2009 41
Error Codes
Error code 3:
Generator too hot (Generator thermoswitch has tripped. Reconnect by pressing
button under oven.)
Error code 4:
Oven too hot (Oven chamber thermoswitch has tripped. Reconnect by pressing
button under oven.)
Error code 5: Fan too hot (Thermoswitch in motor has tripped. Wait for 10 minutes and try again.
Error code 6:
Drain too hot (Drain temperature has been above 75°C for more than 5 min. Check
that jet in drain is working.)
Error code 7:
Oven sensor defective (Temperature sensor in oven chamber not working
properly.)
Error code 8:
Core temp. probe not connected (A program using core temp. probe has been
selected but probe has not been connected.)
Error code 9: Generator sensor defective (Temperature sensor in generator not working.)
Error code 10: Drain sensor defective (Sensor in drain not working. Oven can still be used.)
Error code 11:
Water shortage (Steam generator was not filled within two minutes. Check that the
water has been turned on.)
Error code 12: SSR too hot (Solid-state relay too hot.)
Error code 13:
Generator too hot (Temperature in steam generator higher than 130°C. If fault
recurs, descale generator)
Error code 14: Fan running too slow
Error code 16: IO board too hot
Error code 19: Internal defect (Internal failure in SW process. Restart oven.)
Error code 20: Internal defect (Failure in communication between computer and IO board.)
Error code 21: Invalid program (Program uses function which oven does not support.)
Error code 22:
Program interrupted (Power cut-out during program performance. Cut-out has
lasted so long that program cannot be restarted.)
Error code 24:
Draining failure (Steam generator could not be emptied during flushing. Level
sensor reports high water level when generator is emptied.)
Error code 25: ClimaOptima (ClimaOptima not calibrated. Enter service menu and calibrate.)
Error code 26:
ClimaOptima (ClimaOptima sensor defective. Pressure sensor does not give out
correct signal.)
Error code 28:
Alarm defective (An invalid combination of the main alarms has been detected. The
main alarms are not shown correctly.)
Error code 29:
Door sensor defective (Door sensor does not work. Note: Oven does not stop when
door is opened. Oven can still be used.)
Error code 34: Water pressure too low (Check that water is turned on.)
Error code 36: No detergent (Detergent or rinse aid has run out.)
Error code 38:
Detergent in oven (CombiWash interrupted while detergent in oven chamber. Run
CombiWash step 0 before using oven.)
Error code 39: Memory insufficient (Memory insufficient for this operation.)
Error code 41:
Main alarm (Steam generator thermoswitch has tripped during out-of-service time.
Main contactor disconnected.)
Error code 42:
SW defect (An SW defect has been detected during operation. Steam generator
activated by mistake.)