Balboa Water Group EL/VS 120V-240V - Manual (Page 37)

37
Preset Filter Cycles 300, 300F (Software v. 38)
The first preset filter cycle begins 6 minutes after the UÊ
spa is energized. The second preset filter cycle begins 12
hours later.
For 300-series systems, filter duration is programmable
UÊ
for 2, 4, 6, or 8 hours or for continuous filtration (indicated
by ). The default filter time is 2 hours.
For 300F-series systems, filter duration is programmable
UÊ
for 1, 2, 3, 4, 5, 6, 7, or 8 hours or for continuous filtration
(indicated by ). The default filter time is 1 hour.
To program, press “Temp,” then “Jets.” Press “Temp” to
UÊ
adjust. Press “Jets” to exit programming.
Optional Filter Cycle Programming 500DZ
You are not required to change the filter cycles, but if you UÊ
wish to, press “Time,” “Mode/Prog,” “Mode/Prog” within
3 seconds. SET START FILTER 1 (AM) will appear. Press
“Warm” or “Cool” to reset the filter start time.
Press “Mode/Prog” to see
UÊ SET STOP FILTER 1 and
adjust the time with “Warm” or “Cool” as done above.
Press “Mode/Prog” to see SET START FILTER 2 (PM)
and proceed as above. Press “Mode/Prog” to see
SET STOP FILTER 2 and proceed as above. Press “Mode/
Prog” to confirm.
LOCKING THE PANEL 500DZ
Press “Time,” “Blower,” and “Warm” within 3 seconds. UÊ
The Panel is now locked. To unlock the panel, press the
“Time,” “Blower,” and “Cool” within 2 seconds.
Note: On some systems, “Jets 1,” instead of “Blower,” is
UÊ
used in Lock/Unlock sequences .
LOCKING THE TEMPERATURE 500DZ
Press “Warm,” “Time,” “Blower,” and “Warm” within UÊ
3 seconds. The “Warm” and “Cool” buttons are now
disabled. To unlock the temperature, press “Time,”
“Blower,” and “Cool” within 2 seconds.
Note: On some systems, “Jets 1,” instead of “Blower,” is
UÊ
used in Lock/Unlock sequences.
OZONE
For non-circ systems (if installed) runs during filtration.
For circulation systems (if installed) runs 24 hours.