Balboa Water Group EL/VS 120V-240V - Manual (Page 23)

23
other button to exit.
Locking the Panel
Press “Time” “Jets 1” then “Warm” within 3 seconds.
When locked, the PL “
PL ” light will light. All buttons
are frozen except the “Time” button. To unlock the panel,
press “Time” “Jets 1” then “Cool.”
Locking the Set Temperature
Press “Warm” or “Cool” then “Time,” “Jets 1,” and “Warm”
within 3 seconds to activate the lock. The TL “
TL ” light
will light when the set temperature is locked.
To unlock the set temperature, press “Warm” or “Cool”
then “Time,” “Jets 1” and “Cool.”
Time
When time hasn’t been programmed, the “ ” icon
flashes. (Time settings on EL1000 and some EL2000
systems are not preserved in the event of power loss;
time will have to be reprogrammed upon each power up.)
Initial Start-up
When your spa is first actuated, it will go into Priming
mode (after displaying some configuration information).
Please see “Spa Behavior -- Start-up Information” for
additional information.
The Priming mode will last for up to 4 minutes and
then the spa will begin to heat and maintain the water
temperature in the Standard mode. You can exit Priming
mode early by pressing “Warm” or “Cool.”
Mode/Prog
This button is used to switch between standard, economy,
and sleep modes. Press “Mode/Prog” to enter mode
programming, press “Cool” to cycle through to desired
mode (LCD flashes until confirmed), then press “Mode/
Prog” to confirm selection.
Standard mode maintains the desired temperature. Note
that the last measured spa temperature displayed is
current only when the pump has been running for at least
1 minute. The “
” icon will display until the mode
is changed.
Economy mode heats the spa to set temperature only
during filter cycles. The “
” icon will display until
mode is changed. Pressing “Jets 1” while in Economy
mode puts the spa in Standard-In-Economy mode, which
operates the same as Standard Mode, then reverts to
Economy Mode automatically after 1 hour. Both the
“
” and “ ” icons display in this mode.
During this time, a press of the “Mode/Prog” button will
revert to Economy Mode immediately.
Sleep mode heats the spa to within 20°F (11°C) of the set
temperature only during filter cycles. The “
” icon
will display until mode is changed.
Standby Mode
Pressing “Warm” or “Cool” then “Jets 2” will turn off all
spa functions temporarily. This is helpful when changing
a filter. Pressing any button resets the spa. On some
systems the “Jets 1” button will control the pump in
Standby Mode (“Drain Mode”). In this case, press any
Setting the Time
Once the spa has been properly connected the first time (every power
up on the EL1000 and some EL2000 systems), notice the “
” icon
appearing on the screen.
Press then
Select the hour by pressing
Press
to exit the time setting procedure and enter the
optional filter cycle programming. (Exits programming
on some EL1000 and some EL2000 systems.)
Time Time
Press
to exit programming.
Press to enter.
Select minutes by pressing
Mode/Prog Mode/Prog
Time Time
Mode/Prog Mode/Prog
Mode/Prog Mode/Prog
Or
(Each press changes
the time by 1 minute) Warm Warm
Cool Cool
Or
(Each press changes
the time by 1 minute) Warm Warm
Cool Cool
ML700 Panel Operation
Diagnostic Messages section for the ML700 is unique. Refer to the User Guide for additional information.
User Guide for panel ML700 is 40520-99.
Cool
Warm Time
Mode/Prog
Blower
Jets 2
Light
Jets 1
F2
TL
F1
PL