Acer 350 User Manual
Page 81
Chapter 4
75
Device Address Conflict
Run “Load Default Settings” in BIOS Setup Utility.
RTC battery
Main Board
Allocation Error for device
Run “Load Default Settings” in BIOS Setup Utility.
RTC battery
Main Board
Failing Bits: nnnn
DIMM
BIOS ROM
Main Board
Fixed Disk n
None
Invalid System Configuration Data
BIOS ROM
Main Board
I/O device IRQ conflict
Run “Load Default Settings” in BIOS Setup Utility.
RTC battery
Main Board
Operating system not found
Enter Setup and see if fixed disk and drive A: are properly
identified.
Diskette drive
Hard disk drive
Main Board
Error Message List
No beep Error Messages
FRU/Action in Sequence
No beep, power-on indicator turns off and LCD
is blank.
Power source (battery pack and power adapter). See “Power
System Check” on page 71.
Ensure every connector is connected tightly and correctly.
Reconnect the DIMM.
LED board.
Main Board.
No beep, power-on indicator turns on and LCD
is blank.
Power source (battery pack and power adapter). See “Power
System Check” on page 71.
Reconnect the LCD connector
Hard disk drive
LCD inverter ID
LCD cable
LCD Inverter
LCD
Main Board
No beep, power-on indicator turns on and LCD
is blank. But you can see POST on an
external CRT.
Reconnect the LCD connectors.
LCD inverter ID
LCD cable
LCD inverter
LCD
Main Board
No beep, power-on indicator turns on and a
blinking cursor shown on LCD during POST.
Ensure every connector is connected tightly and correctly.
Main Board
No beep during POST but system runs
correctly.
Speaker
Main Board
Error Message List
Error Messages
FRU/Action in Sequence