Acer 5510 - Manual (Page 47)

41 Chapter 3
General Information
Before You Begin
Before proceeding with the disassembly procedure, make sure that you do the following:
1. Turn off the power to the system and all peripherals.
2. Unplug the AC adapter and all power and signal cables from the system.
3. Remove the battery pack.
NOTE: The screws used to secure bottom case and upper case are more than one type. Please group same
type of screw together as you disassemble the system for service purpose. The image below is for your
reference. Please pay attention to the explanation below.
The screws that secure heatsink cover, MIni PCI cover and HDD cover are with the covers. There is no need
to worry about mix them up.
Screw Type Location Quantity
M2.5*6 Bottom case and IO bezel
(hightlight with yellow circle) 12
M2.5*6 Remove the HDD cover then
you will see. 1
M2.5*6 Remove the Mini PCI cover
then you will see. 3
M2.5*3 Remove the battery then you
will see. 1