Allied Telesis 86251-05 - Manual (Page 39)

Patch 86251-05 For Rapier Switches and AR800 Series Modular Switching Routers SHOW PPP 39
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
Description This command is used to change the configuration parameters of a PPP
interface running over:
■ a synchronous port
■ a DS3 port
■ an ISDN call
■ an ACC call
■ a MIOX circuit
■ TDM group
■ an L2TP calla PPP over Ethernet service
■ a PPP over Ethernet service over a VLAN interface
For PPP over Ethernet and PPP over VLAN links, use the service name
provided by your ISP, or the special service name ANY to specify that any
service is acceptable.
SHOW PPP
Syntax SHOW PPP[=ppp-interface]
where:
■ ppp-interface is the PPP interface number, from 0 to 511.
Description This command displays a list of each PPP interface, users of the interface,
physical interfaces that the interface is running over, and the current state of
the interface.
There have not been any changes to the descriptive text or SHOW output in
this command. The only change is in the Table. Table 1 shows the row which
has changed, with the changed text in bold.
Table 8: Parameters displayed in the output of the SHOW PPP command (showing
the changed row only).
Parameter Meaning
Over The lower layer(s) used by the PPP interface; SYNn, DS3n,
ISDN-callname, ACC-callname, MIOXn-circuitname, TDM-groupname,
VLANn-servicename, TNL-callname.