Allied Telesis 86251-05 - Manual (Page 37)

Patch 86251-05 For Rapier Switches and AR800 Series Modular Switching Routers CREATE PPP 37
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
CREATE PPP
Syntax CREATE PPP=ppp-interface OVER=physical-interface
[other parameters]
where:
■ ppp-interface is the PPP interface number, from 0 to 511.
■ physical-interface is:
• SYNn
• DS3n
• ISDN-callname
• ACC-callname
• MIOXn-circuitname
• TDM-groupname
• TNL-callname (L2TP tunnel)
• VLANn-servicename
Description This command creates the specified PPP interface running over:
■ a synchronous port
■ a DS3 port
■ an ISDN call
■ an ACC call
■ a MIOX circuit
■ TDM group
■ an L2TP call
■ a PPP over Ethernet service
■ a PPP over Ethernet service over a VLAN interface
For PPP over Ethernet and PPP over VLAN links, use the service name
provided by your ISP, or the special service name ANY to specify that any
service is acceptable.
The OVER parameter specifies the physical interface over which the PPP
interface will run. Additional physical interfaces can be added to the PPP
interface using the ADD PPP command.
Examples To create PPP interface 0 CREATE PPP=0 OVER=vlan2-access