Allied Telesis 86251-05 - Manual (Page 19)

Patch 86251-05 For Rapier Switches and AR800 Series Modular Switching Routers 19
Patch 86251-05 for Software Release 2.5.1
C613-10356-00 REV F
Several issues with the DHCP Server have been resolved.
The MRU parameter in the SET PPP command was incorrectly handled as
an interface parameter when the configuration script was generated. This
meant that the OVER parameter was omitted. The MRU parameter is now
correctly handled as a link parameter.
Dynamic interface details were added through the SET INTERFACE
command when the CREATE CONFIGURATION command was executed.
This caused errors on startup. This issue has been resolved.
Port numbers on a Rapier16fi were incorrect. This issue has been resolved.
For details on checking the port numbers on a Rapier16 fi, see “Checking
the Port Map on Rapier16fi Switches” on page 32.
PIM will no longer accept obsolete commands.
TCP checksums in TCP packets passing through the firewall were being
recalculated incorrectly when the TCP setup proxy was disabled, and
enhanced NAT was in use. This issue has been resolved.
The output of the SHOW IP MVR COUNTER command has been corrected.
Also, the output of the SHOW IP MVR command has been modified. The
new output is shown in Figure 1:
Figure 1: Example output from the modified SHOW IP MVR command
PCR: 03351 Module: DHCP Level:
PCR: 03352 Module: PPP Level: 3
PCR: 03353 Module: PPP Level: 3
PCR: 03358 Module: SWI Level: 2
PCR: 03364 Module: PIM Level: 4
PCR: 03369 Module: FIREWALL Level: 2
PCR: 03370 Module: MVR Level: 4
Multicast VLAN
-------------------------------------------------------------------------------
VLAN Mode Imtleave Source Ports Receiver Ports
Current Members Group Address
--------------------------------------------------------------------------------
22 compatible 3 9,10 1-3, 6-7
1,6 235.1.1.1
2,7 234.1.1.1
3 compatible 8 12,13 4,5,8,9
4,8 255.1.1.1
--------------------------------------------------------------------------------