Sony DCR-DVD910 - Manual (Page 119)

119
A
d
d
iti
o
n
a
l In
fo
rm
a
tio
n
Cleaning inside the viewfinder
Remove any dust from inside the
viewfinder by following the steps below.
1 Pull out the viewfinder.
2 While pushing in the tab on the bottom of
the viewfinder with a fine-tipped object
such as a ball point pen, pull the eyecup
block in the direction of the arrow to
remove.
3 Remove dust from the eyecup block with a
camera blower, etc.
4 Press the viewfinder onto the body of the
camcorder.
5 Remove dust from the inside area where
the eyecup block was attached with a
camera blower, etc.
6 Attach the eyecup block to the viewfinder,
pushing it straight on until it clicks.
b Notes
• The eyecup block is a precision part. Do not
disassemble it further.
• Do not touch the lens of the eyecup block.
On charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the POWER
switch is set to OFF (CHG). The pre-
installed rechargeable battery is always
charged while your camcorder is connected
to the wall outlet (wall socket) via the AC
Adaptor or while the battery pack is
attached. The pre-installed rechargeable
battery will be fully discharged in about 3
months if you do not use your camcorder
at all. Use your camcorder after charging
the pre-installed rechargeable battery.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation will not be affected as
long as you are not recording the date.
x Procedures
Connect your camcorder to a wall outlet
(wall socket) using the supplied AC
Adaptor, and leave it with the POWER
switch set to OFF (CHG) for more than 24
hours.
Continued ,