When devices that cause radio wave interference (microwave ovens,
cordless phones, etc.) are placed nearby, the TV SideView function may
not work. In this case, keep such devices away from the access point or
TV, or turn them off.
In the following cases, the TV SideView function may not work. Turn on
the TV and re-connect to the access point.
- Turn on/off the access point power during TV standby mode
- Reset the access point during TV standby mode
- Change the access point channel during TV standby mode
The TV SideView function may not work with business-use access points
that require re-connection periodically.
The TV should be in the power-on or standby mode. Do not turn off the TV
by disconnecting its AC power cord.
Check the following has been set for your TV.
When the access point and TV are connected with wireless LAN
- Built-in wireless LAN model TV is used
- [Built-in Wireless LAN] under [Network] is set to [On]
- [Remote Start] of [Home Network Setup] under [Network] is set to [On]
- TV is connected to the access point
- TV SideView application cannot be used if USB Wireless LAN Adapter is
inserted
When the access point and TV are connected with wired LAN
- [Remote Start] of [Home Network Setup] under [Network] is set to [On]

238