Sony STR-DG910 User Manual
Page 94
94
US
D:\CANNES\SONY_HA\JOB 2007\STR-DG910\IM_910_US\STR-DG910_data\GB06OTH_STR-
DG910-UC.fm
masterpage: Left
STR-DG910
3-094-430-11 (1)
There is no sound from one of the front
speakers.
• Connect a pair of headphones to the
PHONES jack to verify that sound is
output from the headphones. If only one
channel is output from the headphones, the
component may not be connected to the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the component. If both
channels are output from the headphones,
the front speaker may not be connected to
the receiver correctly. Check the
connection of the front speaker which is
not outputting any sound.
• Make sure you have connected to both the
L and R jacks of an analog component, and
not only to either the L or R jack. Use an
audio cord (not supplied).
There is no sound from analog 2
channel sources.
• Check that the INPUT MODE is not set to
“COAX IN”, “OPT IN” or “HDMI IN” for
the selected input (page 78).
There is no sound from digital sources
(from COAXIAL or OPTICAL input jack).
• Check that the INPUT MODE is not set to
“ANALOG” or “HDMI IN” (page 78).
• Check that the ANALOG DIRECT
function is not selected.
• Check that the DIGITAL ASSIGN
function is not used to reassign the audio
input of another source to the selected
input (page 79).
There is pop noise from a specific
component connected to this receiver
when you turn on the component.
• Check that the INPUT MODE is not set to
“AUTO IN” for the selected input (page
78).
The source sound input from the HDMI
jack on the receiver is not output from
the receiver or TV speaker.
• Check the setting of HDMI AUDIO in the
VIDEO menu (page 55).
• Check the HDMI connection.
• The sound is not output when the amplifier
menus are displayed on the TV screen. In
this case, set “OSD” in VIDEO menu to
“OSD OFF”.
• You cannot listen to the Super Audio CD
by connecting HDMI.
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
The left and right sounds are
unbalanced or reversed.
• Check that the speakers and components
are connected correctly and securely.
• Adjust the balance parameters using the
LEVEL menu.
There is severe hum or noise.
• Check that the speakers and components
are connected securely.
• Check that the connecting cords are away
from a transformer or motor, and at least
10 feet away from a TV set or fluorescent
light.
• Move your audio components away from
the TV.
• The plugs and jacks are dirty. Wipe them
with a cloth slightly moistened with
alcohol.
There is no sound, or only a very low-
level sound is heard from the center/
surround/surround back speakers.
• Select a CINEMA STUDIO EX mode
• Adjust the speaker level (page 39).
• Make sure the center/surround speakers
are set to either “SMALL” or “LARGE”
(page 48).
• Make sure the surround back speakers are
set to “SINGLE” or “DUAL” (page 48).