Calibrating the appropriate settings, Automatically (auto calibration), Calibrating the appropriate settings automatically – Sony STR-DG910 User Manual
Page 34: Auto calibration), Before you perform auto calibration

34
US
D:\CANNES\SONY_HA\JOB 2007\STR-DG910\IM_910_US\STR-DG910_data\GB03CON_STR-
DG910-UC.fm
masterpage: Left
STR-DG910
3-094-430-11 (1)
7: Calibrating the
appropriate settings
automatically
(AUTO CALIBRATION)
This receiver is equipped with DCAC (Digital
Cinema Auto Calibration) Technology which
allows you to perform automatic calibration as
follows:
• Check the connection between each speaker
and the receiver.
• Adjust the speaker level.
• Measure the distance of each speaker to your
listening position.
• Measure the speaker polarity.
• Measure the speaker size.
• Measure the frequency characteristics.*
* • DTS 96/24 signals are always played back as 48
kHz when you correct signals.
• The measurement result is not utilized for
signals with a sampling frequency of more than
96 kHz.
The DCAC is designed to obtain proper sound
balance in your room. However, you can
adjust the speaker levels and balance manually
according to your preference. For details, see
“8: Adjusting the speaker levels and balance
(TEST TONE)” (page 39).
Before you perform the Auto Calibration, set
up and connect the speakers (page 15, 16).
• The AUTO CAL MIC jack is used for the
supplied optimizer microphone only. Do not
connect other microphones to this jack.
Doing so may damage the receiver and the
microphone.
• During the calibration, the sound that comes
out of the speakers is very loud. Pay
attention to the presence of children or to the
effect on your neighborhood.
• Perform the Auto Calibration in a quiet
environment to avoid the effect of noise and
get a more accurate measurement.
• If there are any obstacles in the path between
the optimizer microphone and the speakers,
the calibration cannot be performed
correctly. Remove any obstacles from the
measurement area to avoid measurement
error.
Note
The Auto Calibration function does not work in the
following cases.
– ANALOG DIRECT is selected.
– Headphones are connected.
Before you perform Auto
Calibration
?/1
AUTO CAL MIC
SPEAKERS
(OFF/A/B/A+B)
PHONES
VIDEO 3 IN/PORTABLE AV IN
VIDEO
L AUDIO R
MEMORY/
ENTER
CATEGORY
MODE
CATEGORY
2CH
A.F.D.
MOVIE
MUSIC
AUTO CAL
DIRECT
DISPLAY
TUNING MODE
MULTI CHANNEL DECODING
INPUT MODE
INPUT SELECTOR
MASTER VOLUME
TONE MODE
TUNING
TONE
Optimizer microphone