Sony NEX-C3A - Manual (Page 61)

61 GB
Ta
ble of co
nt
en
ts
Sampl
e pho
to
se
ar
c
h
Men
u
search
Inde
x
AF/MF Select
Selects auto focusing or manual focusing.
1 [Menu] t [Camera] t [AF/MF Select] t desired mode.
• If you turn the focusing ring when [Manualfocus] or [DMF] is selected, the image is enlarged
automatically to enable you to check focus area easier. You can prevent the image from being enlarged
by selecting [Menu]
t [Setup] t [MF Assist] t [Off].
(Autofocus) Focuses automatically.
(DMF) After focusing automatically, make fine focus adjustment
manually (Direct Manual Focus).
(Manualfocus)
Adjusts the focus manually. Turn the focusing ring right or left
to make the subject look clearer.
Note
z
Using manual focusing effectively
“Focus fixing” is convenient when you can predict the distance
to the subject. With “Focus fixing,” you can fix the focus in
advance to the distance at which the subject is to pass.
z
To measure the exact distance to the subject
The mark shows the location of the image sensor*. When you measure the exact
distance between the camera and the subject, refer to the position of the horizontal line. The
distance from the lens contact surface to the image sensor is about 18 mm (23/32 in.).
* The image sensor is the part of the camera that acts as the film.
• If the subject is closer than the minimum shooting distance of the attached lens, the focus cannot be
confirmed. Make sure you put enough distance between the subject and the camera.
Bottom
18 mm
(23/32 in.)
Continued r