Alto-Shaam HALO HEAT 500-E/DELUXE - Manual (Page 13)

500-E installation / opEration / sErvicE manual • 11.
The cleanliness and
appearance of this unit will
contribute considerably to
operating efficiency and
savory, appetizing food.
Good equipment that is kept
clean works better and lasts
longer.
CLEAN THE UNIT
THOROUGHLY
AFTER EACH USE
1. Disconnect unit from
power source, and
let cool.
2. Remove, cover or wrap,
and store unused
products under
refrigeration.
3. Remove all detachable items such as wire
shelves, side racks, and any drip pan. Clean
these items separately.
4. Clean interior with a damp cloth or sponge
and any good commercial detergent at the
recommended strength.
5. Spray heavily soiled areas with a water
soluble degreaser and let stand for 10 minutes,
then remove soil with a plastic scouring pad.
NOTE: Avoid the use of abrasive cleaning
compounds, chloride based cleaners,
or cleaners containing quaternary salts.
Never use hydrochloric acid
(muriatic acid) on stainless steel.
6. Clean control panel, door vents, door handles,
and door gaskets thoroughly since these areas
harbor food debris.
7. Rinse surfaces by wiping with sponge and clean
warm water.
8. Remove excess water with sponge and wipe
dry with a clean cloth or air dry. Leave door
open until interior is completely dry. Replace
shelves.
9. Interior can be wiped with a sanitizing solution
after cleaning and rinsing. This solution must
be approved for use on stainless steel food
contact surfaces.
10. To help maintain the protective film coating
on polished stainless steel, clean the exterior
of the cabinet with a cleaner recommended
for stainless steel surfaces. Spray the cleaning
agent on a clean cloth and wipe with the grain
of the stainless steel.
11. Clean glass with a window cleaner.
Always follow appropriate state or local health
(hygiene) regulations regarding all applicable
cleaning and sanitation requirements for foodservice
equipment.
C A R E A N D C L E A N I N G
D A N G E R
DISCONNECT UNIT FROM
POWER SOURCE BEFORE
CLEANING OR SERVICING.
D A N G E R
AT NO TIME SHOULD THE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION OF
ANY KIND. DO NOT USE WATER JET
TO CLEAN.
SEVERE DAMAGE OR
ELECTRICAL HAZARD
COULD RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED