Ferguson Ariva Link TT - Manual (Page 18)

FIRST STEPS
1. Insert the plug of the receiver and other additional devices to a wall socket.
2. Select AV signal source of your television set.
3. The satellite receiver is supplied with reinstalled television channels. In order to watch other,
i.e. non-default channels, you should use the channel search function.
Check all of the connections, i.e. antenna cables, audio and video signal cables, before
connecting the receiver to the mains!
INFORMATION ABOUT THE USER MENU
The user interface allows you to use numerous settings and receiver functions. Some keys on
the remote control unit enable direct access to functions of the receiver. Certain keys have been
described, for example EPG, MENU, OK, or colored keys for ease of usage. Other keys are
multi-functional and their operation depends on the type of device selected by the user.
Hereunder we have presented a brief description of how to use certain receiver functions
available through the user menu.
1. The up/down keys on the remote control are used to move the cursor up and down on the
menu.
2. The left/right keys on the remote control are used to move the cursor left and right, and to
switch options.
3. The OK key is used to enter submenus.
4. The EXIT key is used to exit menus or functions.
5. When operating a submenu, confirm your selection with the OK key.
Powering On/Off
Power ON/Booting
Connect the power cord of your receiver to a mains socket. Turn On the mains switch on the
rear panel to start the booting.
Stand-by
Press the STAND-BY key to switch between Stand-by and operation mode. Timer recordings
will record in this mode.
Deep Stand-by
Hold the STAND-BY key pressed for 3 seconds to switch to the Deep Stand-by
mode. To switch again to operation mode, press the STAND-BY key again.
Timer recordings will not record in this mode.
18