1 installation of batteries, Front panel, Cam module and subscriber's card – Ferguson Ariva Link TT User Manual
Page 10

4.1 Installation of batteries
Remove the cover of the battery compartment on the rear panel of the remote control unit;
slide it downwards and put it aside. Insert two AAA (R03) batteries into the compartment,
observing the indicated polarity. Do not mix old and new batteries, or batteries of
different types. Replace the battery compartment cover. Slide it upwards until it locks in place.
5. Front panel
USB: 2 x USB 2.0.
POWER:
Press power key one time to power off the receiver. Press again to reboot the
receiver. To switch the receiver to Stand-by is only possible with the Stand-by key
on the remote control.
:
Switches to the next/previous channel.
LCD: Displays the channel name, number & functions, in stand-by the time & date.
CI:
Socket for two CAM (Conditional access moduls).
CA:
Socket for a subscriber's card.
Always insert the card with the chip facing up!!!
5.1. CAM module and subscriber's card
Inserting the module and subscriber's card. The conditional access module resembles a PC card
(known as the PCMCIA) for laptop computers. There are different types of CI modules, suitable
for various encoding systems.
1. First, turn off the receiver.
2. Insert the subscriber's card into the conditional access module.
3. Open the tab on the front panel and insert the CI CAM module, forcing it into the socket on
the right side of the front panel. If you want to eject the CAM module, press the black button
next to the CAM socket.
4. After correctly inserting the module, turn on the receiver. You will be able to watch decoded
television channels available through this module and card.
10