elektraLite MM 200 User Manual
Page 7
6
Tips & Tricks
1. If you change the address on MM 200 it may appear not to have accepted that address. Turn MM 200
off wait until the lamp cools down (remember it is not a hot re-strike lamp) and then turn it back on
again.
2. When you turn on MM 200, if there is no data getting to it, then run a cable directly from the controller
to the fixture and test it directly. Do not have any other fixture or cable in line to the MM200 you cannot
operate.
See also other documents in the category elektraLite Lighting:
- eyeBall RGBWA (5-in-1) (15 pages)
- eyeBall DMX channel assignments Menus V2.2 (6 pages)
- eyeBall QUAD 7x12w LEDs (14 pages)
- eyeBall UV/IUV 18-3W LEDs (3 pages)
- Dazer RGB (15 pages)
- Cool White Dazer (12 pages)
- Warm White Dazer (12 pages)
- Variable White Dazer (13 pages)
- Dazer Theatrical White (13 pages)
- Pancake QUAD 36-12W Quad LED Moving Yoke (12 pages)
- Pancake RGBW 108-3W RGBW single source LEDs (13 pages)
- 1018 QUAD 18-12w QUAD LED (19 pages)
- 1018 RGBWA (5-in-1) (18 pages)
- ML-602 60W LED Moving Head Profile Spot (9 pages)
- LXE 700 Spot (20 pages)
- LXE 700 Wash (19 pages)
- PaintCan 2.0 (21 pages)
- CP10xt Manual (49 pages)
- CP10xt Quick Start (2 pages)
- CP16/24 (32 pages)
- MY 250 (25 pages)
- CP100xt Manual Part One (91 pages)
- CP100xt Manual Part Two (109 pages)
- CP100 Manual Part One (72 pages)
- P100 Manual Part Two (80 pages)
- CP1 (25 pages)
- CP3 (18 pages)
- CP20xt (55 pages)
- CP20xt (3 pages)
- MB 150 (19 pages)
- MM 150 (19 pages)
- MY 150 (23 pages)
- Elektrik Eye (22 pages)
- MY 250w (2 pages)
- MY 250I (25 pages)
- MY 575w (24 pages)
- Moving Yoke 120v Spot (27 pages)
- UFO 8 (9 pages)
- elektraFog 1000w element Fog Machine (5 pages)