elektraLite MM 200 - Manual (Page 2)

1
INTRODUCTION:
Thank you for choosing Elektralite’s MM 200 fixture.
Please read the User Manual carefully and keep it in a safe place after reading it.
MM 200 is very easy to install and use, once you have read the manual. Failure to do so could result in damage
to the fixture, which will not be covered under warranty so please take the time to read it.
When you unpack the device you should find inside the box: the fixture, a 120 volt power cable, a 3 pin DMX
signal cable, a safety cable and of course this CD. Please check carefully that there is no damage caused by
transportation. Should there be any, consult your dealer immediately and don’t install it.
Features
Pan 170° / Tilt 85°
10 colors plus rainbow effect
8 gobos
Strobe : with a frequency of 0~7 flashes per second.
Digital address and function setting
High speed pan & tilt movements
SAFETY INSTRUCTIONS
A Word of Caution.
Please remember you will be working with 120 volts and you can suffer electric shock from any exposed lives
wires. So please be careful at all times and behave wisely.
Now you’re MM 200
left Elektralite’s factory in perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely essential that the installer and user follow the safety instructions and
warning notes written in this user manual. Remember any damage caused by disregarding the manual or not
reading it, will not be covered by warranty and Elektralite (or any of its dealers) will not accept responsibility for
any resulting damage or problems.
If the fixture has been exposed to large environmental temperature changes in transit please do not switch it on
immediately it is unpacked. There maybe internal condensation. So leave MM 200 off until it has reached the
running temperature of the venue.
Elektralite’s MM 200 needs to be grounded. Do NOT cut the ground pin or try to use two-core cable to connect
it to a 120-volt receptacle. To be safe and to work properly you must have this fixture grounded.
A qualified electrician must do any electrical work.
Make sure that the power is only 120 volts. This unit will be damaged if you chose to install it at any other
voltage. In an installation it is always best to check the voltage before connecting. And remember never try to
connect your MM 200 live.
Make sure that the power cable is not damaged and never break off the ground pin.
Always disconnect the power, when MM 200 is not in use or before cleaning it. If you don’t, then you are
wasting the lamp life. Merely closing the shutter just stops the light output, it does NOT TURN OFF THE LAMP.
Never try to disconnect your MM 200 by pulling out the plug by tugging the cord.
Never touch MM 200 when powered up. The lamp produces a considerable amount of heat and as a result the
housing does get hot. You can be burnt if you touch it.
Never look directly into the lamp source. Sensitive person could suffer an epileptic shock.