elektraLite MM 200 - Manual (Page 3)

2
Never open MM 200 and look at the lamp when the lamp is still on or when it is turned off but still hot or even
warm. MM 200 uses a discharge lamp, which is volatile. The lamp can explode at anytime. Use extreme
caution and do not expose yourself to it. When replacing the lamp, do not touch any glass part of the lamp.
Only handle by the silver terminal ends. Do not over tighten when installing a new lamp. Hand tight is more
than enough. PLEASE make sure that power to the fixture is disconnected and allow the fixture to cool down
to room temperature before installing a new lamp.
Please keep out of reach of the general public, children and animals.
GENERAL GUIDELINES
MM 200 is a lighting effect for professional use on stages, in clubs, theatres, and so on.
This fixture should only be operated at the voltage, which stated in the technical specifications in the last page
of this manual.
MM 200 is designed for indoor use only.
MM 200 is not designed for permanent operation. Consistent operation breaks may ensure that the device will
serve you for a long time without defects.
Do not shake MM 200.
Do not use physical force when installing or operating MM 200.
While choosing the installation position, please make sure that MM 200 is not exposed to extreme heat,
moisture or dust.
The minimum distance from MM 200 front lens to any illuminated surface must be more than 3 feet.
Please be careful what surface you shine the light onto; light also has heat and this can affect the illuminated
surface. Elektralite will not be responsible for fading, color distortion or heat distortion caused by the light
beam.
When you hang MM 200 please use an appropriate safety cable. Please make sure that any hanging
equipment, like threaded rod or C clamp is appropriate for the job.
Only operate MM 200 after you know its functions. Do not permit operation by persons not qualified.
Please use the original packaging if the device is to be transported. [Beware the majority of shipping
companies will not accept any liability for damage if the fixture is not shipped in the manufacturer’s original box
and insert packaging material].
If this fixture is operated in any other way different to that described in this manual, the fixture could be
damaged and any warranty would be void.