elektraLite CP10xt Manual - Manual (Page 27)

24
instructions for your particular storage device. To start the dump from the CP10xt, go to the memory
dump menu item. Consult the "System Programming" chapter on how to do this.
When your receiver is ready, press "Go" to start the memory dump. The message "SENDING" will
appear on the CP10xt display. After the dump is complete the display will return to its previous state.
The memory dump will require approx. 244K of disk space. When sending a memory dump back to
the CP10xt the message "RECEIVING MEMORY" will appear in the CP10xt display. After the
memory dump has been received the message "MEMORY RECEIVED" will appear in the display.
If the "received" message does not appear, then the memory dump was improperly received. The
memory dump takes several minutes. The CP10xt must not be in enter cue, chase or macro mode
when receiving a memory dump. The contents of the memory messages are shown in the MIDI
implementation chart which follows.
MIDI Implementation Chart
NOTE: All numbers are in hexadecimal unless stated otherwise.
Continuous Controllers (sent and received)
Bn 00 bb Bank select
Bn 01 vv Xfade Speed
Bn 02 vv Chase Speed
n=MIDI channel (0-F)
bb=bank (0-7)
vv=7 bit value (0-7F)
Program Changes (sent and received)
Cn 00 Blackout
Cn vv Cues, Chases and Macros
Note: cues, chases and macros are always preceded by a bank select message.
System Exclusive Messages
F0 00 00 19 06 01 dd ... F7 Memory dump
F0 00 00 19 06 00 F7 Memory dump request
dd=approx. 244K data bytes