Nikon LS-30 - Coolscan III - Manual (Page 26)

- 26 - Setup: Setting the SCSI ID
To change the scanner’s ID, turn the scanner off. Then, using a
screwdriver, turn the dial on the back of the scanner to choose
a new ID.
MADE IN JAPAN
100098
SCSI
SCSI
SCSI NB
TERMINATOR OFF
O N
6 5
4
3 2 1 0
7
Note: The LS-30 conforms to Level 1 of the SCAM (SCSI Con-
figuration Auto-Magically) SCSI-selection standard, which allows
some computers to set the scanner’s ID automatically. If your
computer’s operating system supports Plug&Play and the SCSI host
(computer or SCSI extension board) conforms to SCAM, the scan-
ner may be automatically assigned an ID which differs from that
set using the SCSI ID dial. SCAM will not assign conflicting IDs to
SCSI devices.